Everything below concerns intranasal delivery. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.
Updated 2026-05-02. Numbers and descriptions here follow the published literature rather than marketing material.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Identity and purity of Semax are established mainly by reversed-phase high-performance liquid chromatography coupled with mass spectrometry. The chromatographic trace gives a purity estimate as a percentage of total peak area, while electrospray or matrix-assisted laser desorption ionization confirms the molecular mass against the calculated value. Amino acid analysis and sequence-specific fragmentation provide further confirmation when a supplier's chain of custody is unclear. Vendors frequently quote a purity figure without stating the detection wavelength or the integration method, which limits how far one number can be compared with another.
Stability depends heavily on physical state. Lyophilized powder held dry, cold and dark retains its content over long periods, whereas dissolved peptide begins to change within days at room temperature. The most cited degradation route is oxidation of the methionine residue, which converts the peptide to a sulfoxide form that elutes differently on chromatography. Hydrolysis of amide bonds and adsorption onto container walls contribute smaller losses. Buffers that exclude oxygen from the headspace slow the oxidation pathway, but no single condition prevents all change indefinitely.
Practical handling follows from those properties. Bulk material is best divided into single-use portions soon after receipt, because each thaw exposes the whole container to moisture and temperature cycling. Vials should be allowed to reach room temperature before opening to prevent condensation on the powder. Low-binding plasticware reduces loss of dilute solutions, and sterile filtration is used when a preparation must remain free of microbial growth. Records of batch number, reconstitution date and storage history are what allow a later analytical result to be interpreted meaningfully.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
The peptide is prone to several degradation pathways. Oxidation of the methionine residue produces a sulfoxide that elutes close to the parent peak in many chromatographic systems. Hydrolysis of peptide bonds and deamidation of susceptible residues in related sequences also reduce purity over time. Lyophilised material kept dry at minus twenty degrees Celsius and shielded from light is the most stable form commonly described in laboratory practice.
Material sold for laboratory use varies widely in stated purity and documentation. A certificate of analysis should list the analytical method, the column and detector used, and the observed purity value. Independent verification by an outside laboratory is the practical way to confirm identity when documentation is absent or internally inconsistent. Regulatory status differs by country, and a product legal in one jurisdiction may be unapproved or controlled in another.
Identity and purity of semax are established with reversed-phase high-performance liquid chromatography coupled to ultraviolet detection, usually at 214 nanometres. Mass spectrometry, most often electrospray ionisation in positive mode, confirms the molecular mass and reveals truncated sequences. Amino acid analysis and peptide mapping after enzymatic digestion provide additional structural confirmation. Laboratories typically report purity as the percentage area of the main peak, a figure that does not capture isomeric or oxidised variants unless the method resolves them.
Circulation time for the peptide is short because peptidases cleave it readily. The Pro-Gly-Pro tail is thought to slow breakdown compared with the bare ACTH fragment, but the gain appears modest. Absorption after intranasal dosing is limited, and only a fraction of a dose is expected to reach the central nervous system. Laboratory concentrations therefore sit well above levels achieved systemically, a gap that complicates translation from bench findings to clinical claims.
The mechanisms attributed to semax are inferred from animal and cell studies rather than traced to one confirmed target. The most frequently cited pathway involves increased expression of brain-derived neurotrophic factor and nerve growth factor in hippocampal and cortical tissue. Some work points to engagement of melanocortin receptors, particularly MC4, which the parent ACTH fragment can activate. Effects on dopaminergic and serotonergic signalling have also been reported. No single account explains all observed results, and the relative weight of each pathway remains unsettled.
Published studies examine a fairly narrow set of endpoints. Rodent experiments commonly measure maze learning, infarct volume after induced ischemia, and tissue levels of neurotrophic factors. Clinical reports from Russian centres describe attention, memory and recovery scores in patients after stroke or transient ischemic attack. Most of those human studies are small and few have been repeated by independent groups. Outcome measures differ between studies, which limits direct comparison.
The main approach to managing BPD is through psychotherapy, with a few different interventions having demonstrated a reduction in symptoms and an increase in well-being. While medications do not directly treat BPD, they are beneficial in managing comorbid conditions like depression and anxiety. Evidence states short-term hospitalization does not offer advantages over community care in terms of enhancing outcomes or in the long-term prevention of suicidal behavior among individuals with BPD.
After the Siege of Breslau, the Red Army took the city in May 1945. Breslau, now known as Wrocław, became part of the Republic of Poland. The first Polish team of academics arrived in Wrocław in late May 1945 and took custody of the university buildings, which were 70% destroyed. Parts of the collection of the university library perished during the Soviet offensive in 1945, burned by soldiers on 10 May 1945, four days after the German garrison surrendered the city.
In 1966, E. O. Wilson and his colleagues identified the fossil remains of an ant (Sphecomyrma) that lived in the Cretaceous period. The specimen, trapped in amber dating back to around 92 million years ago, has features found in some wasps, but not found in modern ants. The oldest fossils of ants date to the mid-Cretaceous, around 113–100 million years ago, which belong to extinct stem-groups such as the Haidomyrmecinae, Sphecomyrminae and Zigrasimeciinae, with modern ant subfamilies appearing towards the end of the Cretaceous around 80–70 million years ago. Ants diversified extensively during the Angiosperm Terrestrial Revolution and assumed ecological dominance around 60 million years ago. Some groups, such as the Leptanillinae and Martialinae, are suggested to have diversified from early primitive ants that were likely to have been predators underneath the surface of the soil. During the Cretaceous period, a few species of primitive ants ranged widely on the Laurasian supercontinent (the Northern Hemisphere). Their representation in the fossil record is poor, in comparison to the populations of other insects, representing only about 1% of fossil evidence of insects in the era. Ants became dominant after adaptive radiation at the beginning of the Paleogene period. By the Oligocene and Miocene, ants had come to represent 20–40% of all insects found in major fossil deposits. Of the species that lived in the Eocene epoch, around one in 10 genera survive to the present.
Sources: en.wikipedia.org
The bioavailability of intranasal fentanyl is about 70–90% but with some imprecision due to clotted nostrils, pharyngeal swallow, and incorrect administration. For both emergency and palliative use, intranasal fentanyl is available in doses of 50, 100, 200, or 400 (PecFent) μg. In emergency medicine, safe administration of intranasal fentanyl with a low rate of side effects and a promising pain-reducing effect was demonstrated in a prospective observational study in about 900 out-of-hospital patients. In children, intranasal fentanyl is useful for the treatment of moderate and severe pain and is well tolerated. Furthermore, a 2017 study suggested the efficacy of fentanyl lozenges in children as young as five, weighing as little as 13 kg. Lozenges are more inclined to be used as the child is in control of sufficient dosage, in contrast to buccal tablets.
== U == Ultrasound attenuation spectroscopy UPS – UV-photoelectron spectroscopy USANS – Ultra small-angle neutron scattering USAXS – Ultra small-angle X-ray scattering UT – Ultrasonic testing UV-Vis – Ultraviolet–visible spectroscopy
Omeprazole was first made in 1979 by Swedish AB Hässle, part of Astra AB. It was the first of the proton pump inhibitors (PPI). Astra AB, now AstraZeneca, launched it as an ulcer medicine under the name Losec in Sweden. It was first sold in the United States in 1989 under the brand name Losec. In 1990, at the request of the US Food and Drug Administration, the brand name Losec was changed to Prilosec to avoid confusion with the diuretic Lasix (furosemide). The new name led to confusion between omeprazole (Prilosec) and fluoxetine (Prozac), an antidepressant. Prilosec is owned by Procter & Gamble in alliance with AstraZeneca and the product is designed to address frequent heartburn, which can be triggered by various factors such as certain foods, stress, and smoking. Prilosec was first introduced in 1989 as a prescription medication approved by the FDA for the treatment of severe heartburn. In 2003, Prilosec OTC was launched as the first over-the-counter option for managing frequent heartburn. It is known for its advertising campaign featuring Larry the Cable Guy as the spokesperson for the brand, during the 2010s, emphasizing the concept of "Zero Heartburn".
12 April – US President Joe Biden arrived in County Louth, one of his ancestral homelands, where crowds lined the streets in Carlingford and Dundalk. This followed a visit to Northern Ireland the previous day, as part of a four-day visit to the island of Ireland. 13 April – Biden visited President Michael D. Higgins at Áras an Uachtaráin and Taoiseach Leo Varadkar at Farmleigh House, before addressing a joint sitting of the Oireachtas at Leinster House, with the day ending with a banquet dinner at Dublin Castle. 14 April – Biden visited his ancestral homeland in County Mayo, visiting Knock Shrine and Mayo Roscommon Hospice, ending with a big event with around 27,000 in attendance featuring a public address and performances by The Coronas, The Chieftains and The Academic at St Muredach's Cathedral, Ballina. 17 April – Gerry Hutch was found not guilty of the 2016 murder of David Byrne at the Regency Hotel. 19 April – The 38th Cúirt International Festival of Literature opened in Galway. 22 April – It was announced that an investigator with the Garda Síochána Ombudsman Commission (GSOC) had attended a party celebrating the acquittal of Gerry Hutch the previous Monday, and that he was an associate of a relation of Hutch. The officer resigned when it became known, and GSOC intitiated an investigation. 23 April – An incorporeal Cabinet meeting agreed to send an Emergency Consular Assistance Team to Sudan, via Djibouti – some of them leaving on the night – on a mission to evacuate 150 Irish people and their families from the armed conflict there.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
Suppliers normally quote a percentage of total chromatographic peak area, most often from reversed-phase HPLC. That figure says nothing about what the remaining percentage contains, and it depends on the detection wavelength used. A mass spectrometry result is a separate and stronger check on identity.