This is a working overview of single-use aliquot, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2026-07-28 and is reviewed periodically as new material appears.
Semax is normally supplied as a lyophilized powder, and that form is the most stable. Suppliers commonly recommend storage at -20 °C in a desiccated container protected from light, with short-term handling at room temperature limited to weighing and transfer. Powder that has absorbed moisture degrades faster, so vials should be warmed to ambient temperature before opening to prevent condensation on the contents. Hygroscopic behavior is typical of short hydrophilic peptides, and humidity control matters more than temperature alone for long-term retention.
Once dissolved, the peptide is considerably less stable than the solid. Aqueous solutions are usually prepared at neutral to slightly acidic pH, filtered, and divided into single-use aliquots before freezing. Repeated freeze-thaw cycles are a common cause of avoidable loss and are best prevented by never refreezing a thawed aliquot. Adsorption to plastic and glass surfaces can lower the measured concentration of dilute solutions, particularly below roughly 0.1 mg/mL. Buffer choice, salt content, and container material all influence how much peptide remains detectable after storage.
Identity and purity are established with standard peptide methods. Reversed-phase HPLC with ultraviolet detection near 214 nm resolves the parent peak from deletion and truncation byproducts, and reports typically quote a main-peak percentage. Mass spectrometry by electrospray or MALDI-TOF confirms the expected molecular mass, while amino acid analysis or peptide mapping can verify composition when the sequence itself is in question. A certificate of analysis that pairs a chromatogram with a mass spectrum is more informative than a purity figure alone. Counter-ion content and residual solvents are separate specifications and are frequently omitted.
Semax is a synthetic heptapeptide whose sequence is Met-Glu-His-Phe-Pro-Gly-Pro. The first four residues correspond to the ACTH(4-10) fragment, while the terminal Pro-Gly-Pro extension was added to improve metabolic stability. Its molecular formula is C37H51N9O10S and its monoisotopic mass is approximately 813.9 Da. The compound is classified as a peptide research chemical and as a registered pharmaceutical product in Russia, but it does not hold marketing approval in the European Union or the United States. Naming conventions vary across supplier catalogs.
Development of the compound took place in the Soviet Union during the 1980s, largely through peptide research groups affiliated with the Shemyakin-Ovchinnikov Institute and Moscow State University. Investigators screened fragments of adrenocorticotropic hormone for activity on the central nervous system while attempting to separate cognitive effects from hormonal ones. The shortened sequence was selected because it retained behavioral activity in animal models without stimulating corticosteroid release. Early publications described the molecule as an ACTH(4-10) analog.
| Property | Value | Notes |
|---|---|---|
| Solid storage temperature | -20 °C or below | Desiccated and protected from light |
| Solution storage temperature | -80 °C as single-use aliquots | Avoid repeated freeze-thaw cycles |
| Purity assessment method | RP-HPLC, around 214 nm | Reported as main-peak area percent |
| Identity confirmation method | ESI-MS or MALDI-TOF | Measured mass compared with calculated mass |
| Common synonyms | ACTH(4-10) analog; Met-Glu-His-Phe-Pro-Gly-Pro | Also written as Semaxum in some sources |
Published research covers ischemic stroke, traumatic brain injury, cognitive impairment, optic nerve conditions and attention-related measures. Much of the human evidence comes from small trials conducted in one country, which limits how far the results generalize. Animal models supply the larger share of the data, and effects seen in rodents do not transfer automatically to people. Reviews have noted that methodological reporting is often incomplete, making it difficult to pool results or compare treatment schedules across studies.
Pharmacokinetic accounts emphasize rapid breakdown. After intravenous dosing the intact peptide disappears from blood within minutes, and nasal delivery produces low but measurable concentrations. Metabolites rather than the parent molecule may account for part of the observed activity, although the relative contribution is unresolved. Dosing in the literature varies widely and no optimal schedule has been agreed. These gaps are regularly cited as a reason the findings have not produced broad clinical adoption beyond the original research setting.
研究兴趣主要集中在神经营养因子相关的路径上，包括脑源性神经营养因子与神经生长因子的表达变化。部分实验报告称在特定条件下观察到这些因子的水平上升，但具体信号通路和剂量依赖关系仍未完全厘清。多数公开数据来自细胞模型和动物实验，人体对照研究数量有限。因此，该化合物的作用机制在文献中属于活跃讨论，而非已经确立的定论。
Semax 是一种人工合成的七肽，氨基酸序列为 Met-Glu-His-Phe-Pro-Gly-Pro，单字母缩写记作 MEHFPGP。它被归类为促肾上腺皮质激素片段 ACTH(4-10) 的结构类似物，但并不天然存在于生物体内。母体片段 ACTH(4-10) 的序列为 Met-Glu-His-Phe-Arg-Trp-Gly，Semax 替换了中间两个残基，并在羧基端延长了 Pro-Gly-Pro 三肽。这种延长被普遍认为能提升分子对肽酶的耐受性。
该化合物于二十世纪八十年代在俄罗斯被开发，相关工作由俄罗斯科学院分子遗传学研究所的研究团队主导。开发目标并非复制 ACTH 的完整激素活性，而是寻找保留其神经作用方向、同时去除促肾上腺皮质激素释放效应的短肽片段。研究记录显示，这一方向促成了多个相关短肽的合成与筛选，而 Semax 是其中被研究最广泛的一个。当地文献常以 Семакс 这一名称指代它。
Dissolution is normally performed in water, phosphate-buffered saline, or normal saline, since the peptide is freely soluble in aqueous media and is rarely handled with strong organic solvents. Solution pH should be kept near neutral, because extreme acidity or alkalinity accelerates backbone hydrolysis and encourages oxidation of the methionine side chain. Once dissolved, the material is less stable than the dry powder and is commonly divided into single-use portions and frozen. Buffers containing primary amines, such as Tris, are often avoided because of possible side reactions.
Purity assessment relies mainly on reversed-phase high-performance liquid chromatography, which separates the target heptapeptide from truncated sequences, deletion analogues, and oxidised forms. Mass spectrometry, usually coupled to liquid chromatography, confirms identity through the expected molecular ion and reveals modifications such as methionine sulfoxide formation. Amino acid analysis can verify composition, and tandem mass spectrometry supports sequence confirmation. Ultraviolet detection near 254 to 280 nanometres is convenient because the phenylalanine and histidine residues absorb in that region. Nuclear magnetic resonance is rarely used for routine release testing.
== Further reading == Greer, William R.; Logan, John A.; Willis, Paul S. (1986). America the Bountiful: How the Supermarket Came to Main Street : an Oral History. Washington, D.C.: Food Marketing Institute in cooperation with Beatrice Companies. OCLC 14357784. Longstreth, R. W. (1999). The Drive-In, the Supermarket, and the Transformation of Commercial Space in Los Angeles, 1914-1941. The MIT Press. Lorr, B. (2020). The Secret Life of Groceries: The Dark Miracle of the American Supermarket. Avery. Newman, K. (2012). The Secret Financial Life of Food: From Commodities Markets to Supermarkets (Illustrated edition). Columbia University Press. Petroski, Henry (November–December 2005). "Shopping by Design". American Scientist 93 (6): 491. Sowell, Thomas. Basic Economics (Third Edition, 2007 Basic Books). Pages 92–94 describe the competition between the dominant grocery chains in the United States through the 20th century and beyond. Yee, A. (2003). Shopping at Giant Foods: Chinese American Supermarkets in Northern California (Illustrated edition). University of Washington Press.
March 24, 2010: Republic of Macedonia Last quarter expansion of 1.2% in 2009 officially brought the Republic of Macedonia out of the recession. Overall, the Republic of Macedonia's GDP contracted by 0.7% last year.
Oligoclonal bands of IgG Kappa free-light chain (kFLC) concentrations The measurement of oligoclonal bands requires specialists labs; it is easier to measure kFLC. These two biomarkers are not only elevated in MS, but also to a lesser extent in other diseases including NMOSD. They can be used instead of dissemination in time to diagnose MS where dissemination in space is demonstrated.
Sources: en.wikipedia.org
Temperature If the relative humidity is kept constant, the higher the temperature, the higher the drying rate. Temperature influences the drying rate by increasing the moisture holding capacity of the air, as well as by accelerating the diffusion rate of moisture through the wood. The actual temperature in a drying kiln is the dry-bulb temperature (usually denoted by Tg), which is the temperature of a vapour-gas mixture determined by inserting a thermometer with a dry bulb. On the other hand, the wet-bulb temperature (TW) is defined as the temperature reached by a small amount of liquid evaporating in a large amount of an unsaturated air-vapour mixture. The temperature sensing element of this thermometer is kept moist with a porous fabric sleeve (cloth) usually put in a reservoir of clean water. A minimum air flow of 2 m/s is needed to prevent a zone of stagnant damp air formation around the sleeve. Since air passes over the wet sleeve, water is evaporated and cools the wet-bulb thermometer. The difference between the dry-bulb and wet-bulb temperatures, the wet-bulb depression, is used to determine the relative humidity from a standard hygrometric chart. A higher difference between the dry-bulb and wet-bulb temperatures indicates a lower relative humidity. For example, if the dry-bulb temperature is 100 °C and wet-bulb temperature 60 °C, then the relative humidity is read as 17% from a hygrometric chart.
During the fission, the droplet loses a small percentage of its mass (1.0–2.3%) along with a relatively large percentage of its charge (10–18%). There are two major theories that explain the final production of gas-phase ions: the ion evaporation model (IEM) and the charge residue model (CRM). The IEM suggests that as the droplet reaches a certain radius the field strength at the surface of the droplet becomes large enough to assist the field desorption of solvated ions. The CRM suggests that electrospray droplets undergo evaporation and fission cycles, eventually leading progeny droplets that contain on average one analyte ion or less. The gas-phase ions form after the remaining solvent molecules evaporate, leaving the analyte with the charges that the droplet carried.
==== Eye Caps ==== Eye caps are used when setting the facial features to close the eyes. They are plastic and dome-shaped with sharp protrusions on the convex surface to help shape the eyes and keep them closed. Similarly, mouth formers are used to help shape the mouth. They are usually applied when there are no teeth to shape the lips.
In 1769, William Cullen called attention to diabetic urine that was "insipid" in taste:I myself, indeed, think I have met with one instance of diabetes in which the urine was perfectly insipid; and it would seem that a like observation had occurred to Dr. Martin Lister. I am persuaded, however, that such instances are very rare; and that the other is much more common and perhaps the almost universal occurrence. I judge therefore, that the presence of such a saccharine matter may be considered as the principal circumstance in idiopathic diabetes.In 1788, Thomas Cawley published a case study in the London Medical Journal based on an autopsy of a diabetic patient. He suggested a link between the pancreas and diabetes after observing stones and signs of tissue damage in the patient's pancreas. The significance of this discovery went unappreciated for another hundred years. In 1794, Johann Peter Frank of the University of Pavia found that his patients were characterized by "long continued abnormally increased secretion of non-saccharine urine which is not caused by a diseased condition of the kidneys". He introduced the term insipidus, derived from the Latin ('tasteless'). Frank is often credited as the first physician to describe clinical differences between diabetes mellitus and diabetes insipidus. This claim, however, warrants further examination given prior instances of comparable description (e.g. those by William Cullen). It has been noted that 1792 seems to be the year when "unequivocal" diabetes insipidus was first described in the medical literature.
Sources: en.wikipedia.org
Each freeze-thaw cycle can degrade a fraction of the peptide and promote aggregation. Dividing a stock solution into single-use volumes removes repeated cycling as a variable. It also limits the time a thawed solution spends at room temperature.
A high main-peak percentage says little about identity, counter-ion content, or residual solvents. It also does not distinguish an isomer or a closely eluting analog. Mass confirmation and the accompanying documentation cover those gaps.
Salt form changes mass, solubility, and hygroscopicity, and acetate and trifluoroacetate salts behave differently in solution. Storage guidance still centers on -20 °C for powder and lower temperatures for solutions. The certificate should state which salt is present.
It is a synthetic peptide of seven amino acids. Its backbone corresponds to a fragment of adrenocorticotropic hormone extended at the carboxyl end. The material is distributed as a lyophilized solid for laboratory use.